UNIQUE ID 2 Click example. More...

#include "board.h"
#include "log.h"
#include "uniqueid2.h"

Macros
#define	MIKROBUS_POSITION_UNIQUEID2 MIKROBUS_1
#define	DEMO_TEXT_MESSAGE_1 "MIKROE"
#define	DEMO_TEXT_MESSAGE_2 "UNIQUE ID 2 Click"
#define	STARTING_ADDRESS 0x012345

Functions
void	application_init (void)
void	application_task (void)
int	main (void)

Detailed Description

UNIQUE ID 2 Click example.

Description

This example demonstrates the use of UNIQUE ID 2 Click board by reading and displaying the unique identifier, and by writing data to the memory and reading it back.

The demo application is composed of two sections :

Application Init

Initializes the driver and logger, performs the default configuration and then reads and displays the UID.

Application Task

Writes a desired number of bytes to the memory and then verifies if it is written correctly by reading from the same memory location and displaying the memory content on the USB UART.

Note: When using uniqueid2_write_register() note that setting the DAL bit (CDA) or the WPL bit (SWP) from 0 to 1 is a permanent, irreversible action that freezes the respective register in read-only mode.

Author: Milan Ivancic

Macro Definition Documentation

◆ DEMO_TEXT_MESSAGE_1

#define DEMO_TEXT_MESSAGE_1 "MIKROE"

◆ DEMO_TEXT_MESSAGE_2

#define DEMO_TEXT_MESSAGE_2 "UNIQUE ID 2 Click"

◆ MIKROBUS_POSITION_UNIQUEID2

#define MIKROBUS_POSITION_UNIQUEID2 MIKROBUS_1

◆ STARTING_ADDRESS

#define STARTING_ADDRESS 0x012345

Function Documentation

◆ application_init()

void application_init ( void )

< Logger config object.

< Click config object.

Logger initialization. Default baud rate: 115200 Default log level: LOG_LEVEL_DEBUG

Note: If USB_UART_RX and USB_UART_TX are defined as HAL_PIN_NC, you will need to define them manually for log to work. See LOG_MAP_USB_UART macro definition for detailed explanation.

◆ application_task()

void application_task ( void )

◆ main()

int main ( void )

Macros

Functions